December 10, 2020

A little throwback Thursday

São Paulo, State of São Paulo, Brazil

One of my favorite things to do is find old pictures of me from when I was a little girl... I’m still missing a lot of them but here some of my favorites I’ve found:

My first birthday 1988

Fest junina with my mom and cousins 1990

At the beach with my cousins 1992

                   With my godparents in 1987

Ugh I miss my family in Brasil so much... Thank goodness for all the amazing memories and journal entries I have from all different stages of my life.

Do you have a favorite childhood memory?



1 comment

  1. The SPI standards dictate the level of ending might be} Stylus Pens achieved. The runner spreads the melted plastic alongside the face where the two halves of the mould meet and connects the spur to the gates. There could also be} a number of} runners, guiding the material towards of|in path of} one or a number of} elements. This is the only material waste in injection molding, 15-30% of which can be recycled and reused. Recent advances in 3D printing supplies have enabled the manufacturing of molds appropriate for low-run injection molding at a fraction of the cost. Such small volumes were economically unviable in the past, due to the of} very high price of traditional mould making.

    ReplyDelete